- FAA paused installation of new Juniper Networks routers
- Ground stop on 13 November 2026 disrupted thousands of flights
- Hardware upgrade triggered network overload
- Roughly 3,500 airborne planes safely landed
- Nearly 20,000 flights cancelled across weekend
The Federal Aviation Administration has paused the installation of new Juniper Networks routers following a nationwide ground stop on 13 November 2026 that disrupted thousands of flights. On the afternoon of 13 November, an engineer for contractor L3Harris Technologies was upgrading an FAA radio site in El Dorado, Arkansas, from copper wire to fiber optics. When the newly installed Juniper router was switched on, it and a second Juniper unit installed three weeks earlier in Amarillo, Texas, began flooding the FAA Telecommunications Infrastructure network.
The network received roughly 1,000 connection attempts every four to five seconds. This deluge overwhelmed the agency’s 25-year-old Cisco Systems routers, disrupting pilot communications and radar feeds at 17 of the nation’s 22 regional air traffic control centres. Transportation Secretary Sean Duffy stated that intelligence gathered so far does not point to a cyberattack. Hewlett Packard Enterprise, which owns Juniper Networks, stated that its equipment was working as configured.
The ground stop lasted more than four hours before L3Harris isolated the Arkansas and Texas sites. Roughly 3,500 airborne planes were safely guided to landings, while nearly 20,000 flights were cancelled across the weekend, impacting over 1m passengers. In addition to halting the 3,648-unit rollout, the FAA disabled broadcasting functionality on previously installed Juniper units and reverted to legacy Cisco routers. FAA Administrator Bryan Bedford noted investigators have recreated the incident in testing and are close to identifying the exact root cause.